Wall polisher classification

1. Long rod wall grinding machine

Is mainly used in places where the flatness of large-scale projects is not required, and the polishing speed is very fast (for the wall surface, the ceiling polishing is more cumbersome, even if it is awkward to polish the ceiling.

2. Portable wall polisher

Small and flexible, mainly used in interior decoration, the polished wall is very smooth, at least 2 times lighter than the extension rod.

3. Sand suction machine

The development cost of this machine is high (mainly high technical requirements), the production cost is low, and the machine itself will feel tired when heavier to polish the ceiling.

This picture is provided by the registered user "Warm and Living Home", copyright statement feedback

Attention to the use of wall polisher

1. Please plug in the power supply when using the machine. It is strictly forbidden to operate the appliance illegally in a wet, wet or other state with water.

2. When polishing harder wall putty, please use coarse-grained sandpaper (optional P120 / 180 model), and select 3 or 2 speed switch.

3. When polishing the soft wall putty, please use fine-grained sandpaper (optional P320 / 400 model), and select 4 or 5 speed switch.

4. When polishing the outer wall, the hard grinding disc should be replaced, and the special sandpaper for the outer wall should be selected, and the speed should not exceed 3 gears.

5. It is strictly forbidden to mortgage the grinding disc on the wall for polishing during polishing, otherwise it will cause malfunction or damage to the rotating system

6. Please don't use the grinding machine to polish without the vacuum cleaner working, otherwise it will damage the motor.

7. It is strictly forbidden to step on the wire and beat the motor, and it is strictly forbidden to work in flammable and explosive places.

8. Pay attention to check whether the heat dissipation of each motor is good and whether the air flow is smooth. When assembling and disassembling, make sure that the power supply has been disconnected to avoid unnecessary damage.

9. Pay attention to check whether the operation plate and operation cover are on the same level, otherwise it will affect the operation effect.

10. Clean up the dust in the vacuum cleaner in time, too much dust will affect the vacuuming effect.

11. The grinding machine / vacuum cleaner adopts 220V voltage, please check before using. Please do not use it when the voltage is unstable or too high.

12. It is strictly forbidden to turn on the power when the sand mill is in a free state. You must hold the sand mill to turn on the power.

13. When the machine is idle, it should be stored in a dry and out of reach of children.